conductive angle - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

Noise
Post subject: conductive angle Posted: Wed May 30, 2007 2:40 am

Captain

Joined: Tue May 02, 2006 4:59 am
Posts: 15
hi all,

How can I simulate by ADS the conductive angle of power amplifier ?
I finish the amplifier design and want to verify what class is it.

noise

Top

IR
Post subject: Posted: Wed May 30, 2007 5:10 am

Site Admin

Joined: Mon Jun 27, 2005 2:02 pm
Posts: 373
Location: Germany
Hi Noise,

You need to run a transient simulation (Time domain) on the output signal in which you will see the output waveform. By this you can find the conductance angle and derive in which class your PA works.

Hope this helps!

Regards to all the folks.

- IR

Posted 11/12/2012