Visio for analog schematics and PCB design - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

QuantaSonics
Post subject: Visio for analog schematics and PCB design
Unread postPosted: Mon May 17, 2004 12:12 pm

Has anybody made up stencils for circuit components so as to use Visio for schematic drawing and netlist generation. There is a netlist generator as part of the EE stencil that came with Technical version but the EE stencils are far from complete. Necessary but not sufficient you might say...

Posted 11/12/2012