Spectre Simulation - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

RF-Ban
Post subject: Spectre Simulation
Unread postPosted: Wed May 11, 2005 5:10 am
Offline
Captain

Joined: Sat Feb 26, 2005 5:24 pm
Posts: 16
Location: Lille, FRANCE
Hello every body i have a simple question,
About using spectre (schematic composer) to simulate a coax cable what would be the best tline? mtline? another one? and for mtline how to get R values from an attenuation versus frequency table, in fact using the datasheet of the cable.

Franck

Posted 11/12/2012