Microwave-transparent plastic - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

Curtis Crow
Post subject: Microwave-transparent plastic
Unread postPosted: Thu Nov 25, 2004 7:59 pm
Offline
Captain
User avatar

Joined: Wed Jan 07, 2004 1:27 pm
Posts: 7
What properties in a given plastic material indicate microwave transparency? Is it just dielectric constant and dissipation factor? Can anyone recommend a good microwave transparent plastic that is readily available other than UHMPE?

Top
Profile

DDW
Post subject:
Unread postPosted: Fri Nov 26, 2004 10:21 am

Dielectric constant is a primary selection factor indicating loss or attenuation. Then again consider what is the materials function (what is it used for), rigidity, flexibility, weatherability, UV suceptibility (change properties from exposure), toxicity, thermal characteristics, material cost and manufacturability.

Just a few of the considerations to revue. Make a list of the plastics that are candidates, check the properties of each against your requirements. Make necessary tradeoffs and make your selection.

Posted 11/12/2012