RP-TNC/f calibration 50 Ohm load ? - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.
-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews
 -- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

apr
 Post subject: RP-TNC/f calibration 50 Ohm load ?
Posted: Wed Jul 27, 2005 4:12 pm 
 
Lieutenant

Joined: Wed Jul 27, 2005 3:19 pm
Posts: 2
Hi, I am trying to eliminate as many interconnections as possible to run SWR test of 2.4 GHz omnidirectional 'rubber-duck' WiFi antenna. I am using Agilent E5071B NA. Its port has N/f interface. Antenna has RP-TNC/f interface. My ideal situation would be to use just one N/m to RP-TNC/m adapter (I got one). I need to calibrate Network Analyzer with 50-Ohm Load, Short, Open with that adapter attached.

Does anybody know where can I get those calibration tools with RP-TNC/f interface? Do they exist? Is it possible to make them on my own?

Any ideas will be appreciated.




Posted  11/12/2012