Dipole simulation with ansoft designer - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.
-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews
 -- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

nenou_renardo
 Post subject: Dipole simulation with ansoft designer
Posted: Tue Jan 24, 2006 4:03 am 
 
Lieutenant

Joined: Tue Jan 24, 2006 3:48 am
Posts: 1
Location: Toulouse FRANCE
Hello,

I'm trying to design a dipole antenna with ansoft designer.
This dipole must be connected to RFID CHIP.

Lambda/4 Lambda/4
=======[]=======
RFID
CHIP

I've separated the dipole into two rectangle of lambda/4 (0.1mm separate them) and i've selected the edges and add a port but the software say "edges do not define a valid port".

In the help, i've found that:"The edges must be co-linear"

How can i simulate it???

Thanks You for your future Help



Posted  11/12/2012